One2flush Install
One2flush Installation
In A 1.6gal/flush Low-Flow Kohler
This single-flush toilet is 14 years old and now has a new life. It is now as efficient as most of the new H.E.T.’s (high efficiency toilet) and way more efficient that a lot of the cheaper ones that don’t have any adjustments to fine tune the 1/2 and full flush flush volumes. This toilet easily converts to dual-flush and now uses only 1 gallon on the 1/2 flush! That’s a 37.5% savings with every half flush.
__________________________________________________________
Step-By-Step Detailed Installation Video
In this detailed installation video, the One2flush is installed in an American Standard (5 gallon per flush!) toilet that was installed in this home back in 1973. You’ll see the steps in detail as we convert this toilet to dual-flush. Now, in the half flush mode, this toilet only uses 2 gallons which seems like a lot, but remember, this toilet was wasting 5 gallons per flush. This toilet in the half flush mode is now saving 3 gallons per flush, a 60% savings! Every toilet is a little bit different, so your savings may vary.
__________________________________________________________
Typical Installation Procedure
Before beginning the installation of your One2flush valve; read instructions completely and check that your tank specifications match with the One2flush system.
It fits:
- Front handle toilets left or right
- Corner handle toilets left or right
- End handle toilets left or right
- Center mount option (top or side available)
- Tanks a low as 9″ high
- Works in most older 3.5Gal+ toilets as well as the new 1.6Gal models
Note: If your toilet tank has not been removed in the past ten years it may be necessary to replace the tank seal and hold down bolts after installing the new valve.
TOOLS YOU’LL NEED:
* Standard screwdriver
* Channel Lock Wrench
* Crescent Wrench
* Bucket/ Sponge
